Tiers: may be specified as single-tier (full height), two-tier, three-tier, etc., meaning that the lockers are stacked on top of each other in layers two high, three high, etc. Tiers are commonly up to eight high; on occasion, even more tiers may be found, in the case of very small lockers for such purposes as storing laptop computers. The most common numbers of tiers found in lockers are, in order, one, two, and four; three-tier lockers are rather less common, and other numbers such as five, six, or eight even less common still - seven almost non-existent. Since locker cabinets are most commonly 6 feet (182.9 cm.) high (although there are exceptions), the height of individual lockers varies according to how many tiers are accommodated within the cabinet. The height of individual lockers is usually approximately 6 feet (182.9 cm.) divided by the number of tiers, so that two-tier lockers are about 3 feet (91.4 cm.) high, three-tier lockers 2 feet (61 cm.) high, four-tier lockers 1.5 feet (45.7 cm.) high, and so on. Standard features often vary according to the number of tiers: single-tier lockers usually include a shelf about a foot (roughly 30 cm.) from the top, and a hanging rail (sometimes with one or two hooks) immediately underneath that, at the top of the large compartment beneath the shelf; two- or three-tier lockers usually lack the shelf, but include the hanging rail; lockers with four or more tiers usually have none of these fittings, but consist of just the bare compartment.
Stepped/2-step lockers are two-tier lockers, usually available only in 15-inch (38-cm.) width; but the compartments and their doors have an L-shaped cross-section, which causes the division between the doors to follow a zigzag pattern. This configuration enables more hanging height to be included in both upper and lower lockers; but part of each compartment (the lower part of the upper one and the upper part of the lower one) will be only half the usual width of two-tier lockers.
This film roll is interesting in that it doesn't point you to the location of resources; rather, it points you to an item you can use to gain some valuable stuff. Located in the Safety Deposit Room, grab the film roll by keying in the proper code to unlock the locker its sealed in. Though, you're by no means required to develop the film roll to get the items its photograph hints towards, but it does help direct you towards what you need to do

Storage Auctions in Alabama | Storage Auctions in Arizona | Storage Auctions in California | Storage Auctions in Florida | Storage Auctions in Colorado | Storage Auctions in Delaware | Storage Auctions in Florida | Storage Auctions in Georgia | Storage Auctions in Illinois | Storage Auctions in Kansas | Storage Auctions in Kentucky | Storage Auctions in Maryland | Storage Auctions in Massachusetts | Storage Auctions in Mississippi | Storage Auctions in Missouri | Storage Auctions in Nevada | Storage Auctions in New Hampshire | Storage Auctions in New Jersey | Storage Auctions in New Mexico | Storage Auctions in New York | Storage Auctions in North Carolina | Storage Auctions in Ohio | Storage Auctions in Oklahoma | Storage Auctions in Pennsylvania | Storage Auctions in South Carolina | Storage Auctions in Texas | Storage Auctions in Vermont| Storage Auctions in Virginia
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together.
Plastic Lockers are ideal for high-humidity applications, as these virtually maintenance-free lockers will never rust, rot, corrode or fade. These lockers are available in multiple configurations and are backed by a 15-year warranty. Optional configurations like Lattice Lockers, or doors with other non-standard vents can be obtained through ASI Storage Solutions. Please consult our customer service team to be advised on changes in pricing and delivery lead times for all non-standard items.
3-Tier Locker compartments measure 19 in. high and 3-Tier Locker compartments measure 19 in. high and include two side hooks and number plates. Doors have top and bottom louvers for air ventilation. Recessed handle with finger-lift latch accommodates a standard padlock (not included). Welded steel construction with powder coat finish available in 17 colors. Overall size of locker ...  More + Product Details Close

Buy Locker Denver

×