THE OPERATOR (INCLUDING EMPLOYEES, AGENTS, AND/OR CONTRACTORS OF THE OPERATOR, THE EVENT AND THE VENUE) SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL LOSSES ARISING FROM THE LOSS OF OR INABILITY TO ACCESS ITEMS STORED WITHIN THE LOCKERS AND LOCKER FACILITY, INCLUDING BUT NOT LIMITED TO, MISSED AIRLINE FLIGHTS OR OTHER TRANSPORTATION OR LOSS OF BUSINESS AND SHALL NOT BE LIABLE FOR LOSS OF PROPERTY DUE TO CUSTOMER’S LOSS OF LOCKER KEYS OR COMBINATIONS.
Stepped/2-step lockers are two-tier lockers, usually available only in 15-inch (38-cm.) width; but the compartments and their doors have an L-shaped cross-section, which causes the division between the doors to follow a zigzag pattern. This configuration enables more hanging height to be included in both upper and lower lockers; but part of each compartment (the lower part of the upper one and the upper part of the lower one) will be only half the usual width of two-tier lockers.
With the same standard features as the Traditional line, the Traditional Plus Collection is intended for more rugged applications and has matching finish on all sides and top for a finished look. Phenolic Lockers are the material of choice when a high degree of design flexibility is desired or where durability and strength are required. These lockers are fabricated to stand the test of time. The dense components, combined with stainless steel brackets and fasteners, stand up to the most extreme conditions of moisture and humidity. Phenolic is impact, water and corrosion resistant, and does not support bacteria.
Lockers are usually physically joined together side by side in banks, and are commonly made from steel, although wood, laminate, and plastic are other materials sometimes found. Steel lockers which are banked together share side walls, and are constructed by starting with a complete locker; further lockers may then be adding by constructing the floor, roof, rear wall, door, and just one extra side wall, the existing side wall of the previous locker serving as the other side wall of the new one. The walls, floors, and roof of lockers may be either riveted together (the more traditional method) or, more recently, welded together.
Clean/dirty lockers normally have two or three parts within the locker. One part is meant for dirty or clothes that are worn, and the other side for clean clothes. These lockers are meant for hospitals or other medical workplaces where it is useful to keep work and personal clothes apart to reduce the risk of infection. These lockers are also useful for factories where work clothes can become dirty and it can be very useful to keep them apart from personal clothes.
The storage lockers were a “pilot,” the kind of small test that city government frequently uses to test a new or controversial idea. The city offered up the lockers for individuals to use for months-long stretches. At the time, city officials warned that “misuse of the lockers, vandalism, or other unanticipated results,” could force them to cancel the project.