The RPD's Safety Deposit Room is packed with useful resources, but not all of them are accessible at first. To get everything in those pesky electronically sealed lockers, you'll need to get two replacement keypad keys. These can be found inside Pocket Safes scattered throughout the police station. To open a Pocket Safe, simply examine it and then input the correct button pattern. This require a little bit of trial and error to find out, but keep at it and you'll unlock it in no time. Below you can find details on where each Pocket Safe is located.
This film roll is interesting in that it doesn't point you to the location of resources; rather, it points you to an item you can use to gain some valuable stuff. Located in the Safety Deposit Room, grab the film roll by keying in the proper code to unlock the locker its sealed in. Though, you're by no means required to develop the film roll to get the items its photograph hints towards, but it does help direct you towards what you need to do
Bank size: It does not necessarily refer to the total number of compartments, but rather the number of compartments wide the entire cabinet is. So a bank of three may contain six lockers, for example, if they are two-tier lockers. In short, the total number of lockers is the bank size multiplied by the number of tiers. Sometimes the term "bay" is used instead of "bank", although "bank" appears to be the more standard term; on other occasions, "bay" refers to a single locker width within a bank, including all tiers of locker directly on top of each other.
Day use lockers are available throughout the facility and are the lockers that have hooks on them. Day use lockers are first come first serve each day. It is recommend that members bring their own lock (or purchase one from the service center for $7) to secure their belongings. Day use lockers must be cleaned out and the lock removed each night before closing. Items left overnight will result in the lock being cut and the items being logged in the lost and found.
Gun lockers or safes are specifically designed for the secure storage of guns and ammunition. They broadly resemble normal single-tier lockers, but tend to be slightly less high than normal single-tier lockers, and are often free-standing, and not banked together. They are fitted with internal racks designed for holding firearms. They have a shelf at the top like normal single-tier lockers, although in this case it is closed and locked by a separate door, because of legal requirements in some countries that firearms and ammunition be stored and locked separately. They always lock with three-point locking, which is in some countries a legal requirement for the storage of firearms. Sometimes they are made of the standard kind of sheet steel used in manufacturing normal lockers, and sometimes they are made of extremely thick heavy-duty steel and in this case resemble a safe more than a normal locker. In Australia there are strict regulations governing the storage of firearms following the Port Arthur massacre in Tasmania, Australia on 28 April 1996, and cabinets used for storing firearms must be bolted to the floor or a wall if the cabinet is under a certain weight. Dedicated gun lockers are likely to include holes in the cabinet to accommodate such bolting. Several locker manufacturers also offer dedicated gun lockers.

Don't take chances with a small storage company that doesn't have the nationwide resources like CubeSmart to ensure that customer service is prioritized. We're in it for the long-haul and we recognize that your satisfaction is instrumental to our success. We think you should expect more from storage and our locations in and around Denver are ready to exceed your expectations.
Stepped/2-step lockers are two-tier lockers, usually available only in 15-inch (38-cm.) width; but the compartments and their doors have an L-shaped cross-section, which causes the division between the doors to follow a zigzag pattern. This configuration enables more hanging height to be included in both upper and lower lockers; but part of each compartment (the lower part of the upper one and the upper part of the lower one) will be only half the usual width of two-tier lockers.
Tiers: may be specified as single-tier (full height), two-tier, three-tier, etc., meaning that the lockers are stacked on top of each other in layers two high, three high, etc. Tiers are commonly up to eight high; on occasion, even more tiers may be found, in the case of very small lockers for such purposes as storing laptop computers. The most common numbers of tiers found in lockers are, in order, one, two, and four; three-tier lockers are rather less common, and other numbers such as five, six, or eight even less common still - seven almost non-existent. Since locker cabinets are most commonly 6 feet (182.9 cm.) high (although there are exceptions), the height of individual lockers varies according to how many tiers are accommodated within the cabinet. The height of individual lockers is usually approximately 6 feet (182.9 cm.) divided by the number of tiers, so that two-tier lockers are about 3 feet (91.4 cm.) high, three-tier lockers 2 feet (61 cm.) high, four-tier lockers 1.5 feet (45.7 cm.) high, and so on. Standard features often vary according to the number of tiers: single-tier lockers usually include a shelf about a foot (roughly 30 cm.) from the top, and a hanging rail (sometimes with one or two hooks) immediately underneath that, at the top of the large compartment beneath the shelf; two- or three-tier lockers usually lack the shelf, but include the hanging rail; lockers with four or more tiers usually have none of these fittings, but consist of just the bare compartment.

Buy Denver Lockers

×